Material models in 3D CSFM (AS 3600)

Concrete - Strength

The concrete model implemented for strength calculations in CSFM is based on the parabolic-plastic stress-strain curve. The tensile strength is neglected, as it is in classic reinforced concrete design.

\[ \textsf{\textit{\footnotesize{Fig. 47\qquad The stress-strain diagram of concrete for Strength analysis}}}\]

The implementation of CSFM in IDEA StatiCa Detail does not consider an explicit failure criterion in terms of strains for concrete in compression (i.e., after the peak stress is reached, it considers a plastic branch with ε_cp in maximum value 5%, while AS 3600 Cl. 8.3.1 assumes ultimate strain of less than 0.3%). This simplification does not allow the deformation capacity of structures failing in compression to be verified. However, the strength is properly predicted when the increase in the brittleness of concrete as its strength rises is considered by means of the \(\eta_{fc}\) reduction factor defined in fib Model Code 2010 as follows:

\[f'_{c,lim}=\alpha_{2}\cdot\phi_{s} \cdot \eta_{fc}\cdot f'_{c}\]

\[{\eta _{fc}} = {\left( {\frac{{30}}{{{f'_{c}}}}} \right)^{\frac{1}{3}}} \le 1\]

where:

α₂ is the reduction factor of concrete compressive strength defined in AS 3600 Cl. 8.3.1
When using a parabola-rectangle stress-strain diagram, it is necessary to reduce the maximum compressive stress by this factor. This averages the stress distribution in the compression zone in such a way that the resulting compressive strength is less than or equal to the compressive strength calculated using a stress-strain diagram with a decreasing plastic branch. An analogous approach is defined for the Rectangular stress block in Chapter 8.1.3.

Φ_s is the stress reduction factor for concrete. The default value is set according to AS 3600 Table 2.2.3.

f'_c is the concrete cylinder strength (in MPa for the definition of \( \eta_{fc} \)).

Reinforcement

A perfectly elasto-plastic stress-strain diagram with a defined yield point for the non-prestresses reinforcement is considered, see AS 3600 Section 3.2. The definition of this diagram only requires the basic properties of the reinforcement to be known – the strength and modulus of elasticity.

The reinforcement stress-strain diagram can be also defined by the user, but in this case, it is impossible to assume the tension stiffening effect (it is impossible to calculate crack width). 

\[ \textsf{\textit{\footnotesize{Fig. 48 \qquad Stress-strain diagram of reinforcement}}}\]

where:

Φ_s is the strength reduction factor for reinforcement. Where the default value is set according to AS 3600 Table 2.2.3.

f_y is the yield strength of reinforcement

E_s modulus of elasticity of reinforcement

Tension stiffening (Fig. 49)  is accounted for automatically by modifying the input stress-strain relationship of the bare reinforcing bar in order to capture the average stiffness of the bars embedded in the concrete (ε_m).

\[ \textsf{\textit{\footnotesize{Fig. 49\qquad Scheme of tension stiffening.}}}\]